[. . . ] E) Constantly check food frying to avoid that the overheated oil may become a fire hazard. G) This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. H) Children should be supervised to ensure that they do not play with the appliance. I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. [. . . ] If the appliance is connected directly to the electricity supply, an omnipolar switch with a minimum contact opening of 3 mm must be placed in between the two; its size must be suitable for the load required and it must comply with - 17 - current legislation. € The minimum distance between the support surfaces of the cooking pots on the cooker top and the lowest part of the cooker hood must be at least 45 cm. If a connection tube composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source. Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig. - In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air. € We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier. € If the appliance is supplied with the small cupola M remove it by releasing it as indicated in Fig. Before proceeding with the assembly operations, for easier manoeuvrability of the appliance disengage the anti-grease filter by pulling handle B as indicated in Fig. If one owns a model with perimeter suction panel, before carrying out this operation, perform the following phases: - Open panel C as indicated in Fig. Slide the top connector inside the lower duct and place this on the body (Fig. Pull out the top duct as far as the bracket and secure it using screws B (Fig. To transform the hood from a ducting version into a filtering version, ask your dealer for the charcoal filters and follow the installation instructions. € Filter hood: Please note: The filters must be ordered from your dealer as an accessory. - To transform the hood from the SUCTION version to the FILTERING version, charcoal filters must be ordered from your dealer as an accessory. Unlike traditional carbon filters, this carbon filter can be washed and reactivated for approximately 12-15 times. With normal hood use, this filter should be cleaned once every 2-3 months. The filter can be washed into a dishwasher at the highest temperature using a standard dishwasher detergent. After washing, dry the filter in the oven at 100° C for 10-15 minutes to reactivate it. The filter will retain its odour-absorbing capacity for three years, after which it will have to be replaced. 14 loosen the screws already installed inside the hood and install the bracket using the previously-removed screws. [. . . ] Remove excess water without damaging the filter, remove the plastic parts, and let the mat dry in the oven for at least 15 minutes approximately at a maximum temperature of 100°C. To keep the regenerable charcoal filter functioning efficient this operation must be repeated every 2 months. These must be replaced at least every 3 years or when the mat is damaged. € Before remounting the anti-grease filters and the regenerable active charcoal filters it is important that they are completely dry. [. . . ]